Firebox Liner Panels - Aarrow Signature Inset 5 Operating & Installation Manual

FIREBOX LINER PANELS

The Aarrow Signature Inset 5 stoves use firebox
liner
panels to the sides and back. See fig 2
The throat plate sits on top of the sides and rear
panels. These should come fitted to your stove, if
however they are not, proceed as follows to fit
them.
•
Open the fire door.
•
Remove the cast fuel retaining bar, by lifting
free from the front brace.
•
Set the small liner into the back of the
firebox.
•
Insert the side liner panels. (See Fig. 3)
•
Fit the throat plate with the single bend to
the front facing up. The projecting lugs sit
on top of the side liners. The long centre tab
on the back edge rests on the tertiary air
Fig.4 & 5)
•
Replace the front fuel retaining bars.
Note: Neither the rear firebox liner nor the side
firebox liners are 'handed', both faces are
suitable for direct contact with the fire bed.
Note : Cracking of the liner panels does not
effect efficiency.
Fig. 2. Overall View Of Liners
& Throat Plate Assembly
Aarrow Signature Inset 5
bar above the rear liner. (See
Fig. 3. Liners Inserted
Fig. 4. Inserting The Throat Plate
Tertiary air bar
Fig. 5. Liners & Throat Plate Correctly Fitted
INSTALLATION
Page 13