Table of Contents
Advertisement
Operating & Installation Manual
The Becton
MK 3
Range of Gas Stoves
(Becton 7 MK 3 Gas Stove)
PLEASE RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE
Aarrow Fires Ltd
The Fireworks
Bridport
Dorset, DT6 3BE
Great Britain
FOR USE IN COUNTRIES
GB & IE
Tel. (44) 01308 427234
Fax. (44) 01308 427441
Rev 11
www.aarrowfires.com
Part No. AFS1125
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Aarrow Becton 7 mk3
Summary of Contents for Aarrow Becton 7 mk3
- Page 1 Operating & Installation Manual The Becton MK 3 Range of Gas Stoves (Becton 7 MK 3 Gas Stove) PLEASE RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE Aarrow Fires Ltd The Fireworks Bridport Dorset, DT6 3BE Great Britain FOR USE IN COUNTRIES GB &...
- Page 2 This booklet has copyright & may not be copied in whole or part or used for any purpose other than that for which it is supplied without express written consent from Aarrow Fires Ltd. Becton Bunny & Becton 7 mk3 Gas stoves...
-
Page 3: Table Of Contents
Combustible Shelf Clearances Hearth Requirements Connecting The Gas Supply Pressure Test Sequence Fire Testing Installation Check List Becton Bunny & Becton 7 mk3 Gas stoves Page SERVICING Details of Pilot Assembly Door Trim Fire Door Glass & Seal Burner Assembly... -
Page 4: Introduction
• Always grip with the palms of your hands. Do not use fingertips for support. • Always keep the stove as close to the body as possible. This will minimise the cantilever action. • Use gloves to provide additional grip. Becton Bunny & Becton 7 mk3 Gas stoves... -
Page 5: Important Notices
Becton Bunny & Becton 7 mk3 Gas stoves INTRODUCTION Warning: THIS GAS APPLIANCE MUST BE SERVICED EVERY TWELVE MONTHS BY A QUALIFIED GAS ENGINEER. -
Page 6: Operating Instructions
0.254 m hour NOx CLASS CLASS 4 Becton 7 Natural Aeromatic AC13/112511 (mod 334) Bray 82-700 5.0 kW 0.529m /hour 3.5mb 3.3 kW 0.349 m /hour CLASS 4 FIRE DIMENSIONS Fig. 2 Becton Bunny & Becton 7 mk3 Gas stoves... -
Page 7: Fitting The Lining Panels
First position the tall edge into the radius at the front of the fire.(See Fig.3b below) Fig. 3b Fitting the R/H side lining Becton Bunny & Becton 7 mk3 Gas stoves OPERATING INSTRUCTIONS 3. Then rotate the rear edge until the top faces match up the angle faces at the rear of the fire. -
Page 8: Arranging The Coals
(Fig 4b) Fig 4b Step 3 Becton 7 only. Locate 2 off end coals each side of the base matrix. (See underside of coals for hand identification) (Fig 4c). Fig 4c Becton Bunny & Becton 7 mk3 Gas stoves... -
Page 9: Lighting & Controlling The Fire
Step 1b. Keep the control knob pressed in and turn anti-clockwise to the pilot position. (Fig 5b) Fig 5b Becton Bunny & Becton 7 mk3 Gas stoves OPERATING INSTRUCTIONS Step 1c. Keep the control knob pressed in for a further 15 seconds and then release. The pilot will remain alight. - Page 10 In this situation no more attempts at operating the appliance should take place and your qualified gas engineer should be contacted to investigate and rectify the problem. Becton Bunny & Becton 7 mk3 Gas stoves...
-
Page 11: Installation
Building Regulations. The minimum effective height of the Becton Bunny & Becton 7 mk3 Gas stoves chimney must be at least 3 metres and when warm the flue draught should be between 0.05 and 6mb (0.5mm to 6mm water gauge). - Page 12 (Ref. Fig. 6c). It is recommended that a smoke test is performed inside the fire to ensure that adequate flue draw is evident. Fig 7a Becton Bunny & Becton 7 mk3 Gas stoves...
-
Page 13: Fire Location
INSTALLATION non- combustible closure plate, incorporating access for cleaning debris. Fig. 7b. Fig. 7c Becton Bunny & Becton 7 mk3 Gas stoves non- combustible closure plate, incorporating access for cleaning debris. Fig. 7d. FIRE LOCATION The appliance must not be installed in a room or space, which contains a bath or shower. -
Page 14: Combustible Shelf Clearances
1. Graph 1.Combustible Shelf Clearances The recommended minimum height from the extreme top surface of the fire to the underside of a non combustible shelf is 100mm. Becton Bunny & Becton 7 mk3 Gas stoves... -
Page 15: Hearth Requirements
Becton Bunny & Becton 7 mk3 Gas stoves To check the pressure to the burner it is necessary to ignite the appliance and set to 'high rate'. -
Page 16: Fire Testing
This is perfectly normal and is due to the paint curing, it will disappear after the first few hours. Once the spillage test is complete open windows and doors to ventilate the area. Becton Bunny & Becton 7 mk3 Gas stoves... -
Page 17: Installation Check List
Part J of Schedule 1 to the Building regulations. Print name and title...Profession... Capacity...Telephone... Address...Postcode... Signed...Date... Registered membership of..(e.g. CORGI, OFTEC, HETAS, NACE, NACS)... Becton Bunny & Becton 7 mk3 Gas stoves CHECKLIST Outlet Details: Complies with: visual sweeping coring ball... -
Page 18: Servicing
This in turn will reduce condensation in the chimney and any associated flue problems. The pilot can be viewed through the L/H & centre front slots in the base matrix. Fig. 10 Becton Bunny & Becton 7 mk3 Gas stoves... -
Page 19: Door Trim
The tracery can now be removed. (See Fig. 11c below) Fig. 11c Untightening the single tab Becton Bunny & Becton 7 mk3 Gas stoves Step 3 The trim will now lift off the remaining 2 tabs. See Fig. 11d. -
Page 20: Burner Assembly
(See “Safety Notices” under ‘Coal set’ on page 4). Step 5 Replace the coal set. See assembly procedure on page Step 6 Replace glass/gasket assembly and glass frame. Step 7 Close fire door. Becton Bunny & Becton 7 mk3 Gas stoves SERVICING... -
Page 21: Annual Service
Step 11 Replace fire box linings. Step 12 Replace coal set. Becton Bunny & Becton 7 mk3 Gas stoves Step 13 Replace glass/gasket and glass frame and close the fire door. Step 14 Carry out spillage test as per instructions on page 16. -
Page 22: Fault Diagnosis
Check all pipe connections check main valve magnet Investigate flue systems Becton Bunny & Becton 7 mk3 Gas stoves Does the main burner light? Fire satisfactory Is the main injector blocked? Clean and replace as necessary... -
Page 23: Spare Parts
Paint- Matching aerosol paint to tone in any connecting flues, pipes or surrounding metalwork Tracery or Trim - Note: When fitted one replaces the other. Becton Bunny & Becton 7 mk3 Gas stoves Add on Canopies Bunny - Low available only Size: 400mm wide x 345mm deep. -
Page 24: Notes
NOTES Becton Bunny & Becton 7 mk3 Gas stoves... -
Page 25: Notes
NOTES Becton Bunny & Becton 7 mk3 Gas stoves... -
Page 26: Spare Parts List
Comprises 2 Hinges & 4 Fixings Per Set. Bunny Visual Aid (not to scale) Part No. AFGS1074 AFGS089 AFGS090 AFGS091A AFGS1073 AFS047 Becton Bunny & Becton 7 mk3 Gas stoves SPARE PARTS Becton 7 Part No. AFGS1075 AFGS089 AFGS090 AFGS091 AFGS1073 AFS047... - Page 27 Magnet Lock and Trim 12. Glass Replacement Kit with Gasket & Fixings. 13. Hotplate 14. Flue Outlet Spigot Becton Bunny & Becton 7 mk3 Gas stoves Bunny Visual Aid (not to scale) Part No. AFGS1085 AFGS1076 AFGS080 AFS094A AFGS1078...
- Page 28 22. Aarrow Fires Gauntlet Gloves Bunny Visual Aid (not to scale) Part No. AFGS093 AFGS094 AFGS1084 AFGS025 AFS1125 AFS1013 AFS997 Becton Bunny & Becton 7 MK3 Gas stoves SPARE PARTS Becton 7 Part No. AFGS1072 AFGS093 AFGS094 AFGS1084 AFGS025 AFS1125 AFS1013 AFS997...
-
Page 29: Guarantee
Annual service on page 30 should be completed by your service engineer. Becton Bunny & Becton 7 mk3 Gas stoves All Guarantee periods commence on the date of purchase and are non-transferable. -
Page 30: Service Record
Should you have any questions about your Becton Gas Stove that is not covered in this manual please con- tact your Aarrow retailer. Please keep all repair receipts safely. Please ensure you have this manual available when an engineer visits as they will complete the service record chart. Becton Bunny & Becton 7 mk3 Gas stoves... -
Page 31: Lifetime Guarantee
Lifetime Guarantee For your peace of mind Aarrow Fires gives a Lifetime Guarantee against manufacturing defects of the main body* of its Becton range of fires. Additionally, all other parts are covered by a one year no quibble replacement guarantee. This guarantee covers replacement of the item only and does not extend to any other costs, including labour, incurred in its replace- ment. -
Page 32: Final Factory Checklist
HOTPLATE OPERATING INSTRUCTIONS GAS COCK FEET & FIXINGS Please ensure the enclosed registration card is completed and returned to Aarrow Fires and the following information completed for your own information. Date of Purchase... Name and address of supplier... * Please ensure installer completes INSTALLATION CHECK LIST details on page 17 of this manual.
Need help?
Do you have a question about the Becton 7 mk3 and is the answer not in the manual?
Questions and answers