Set Up - Clearaudio Concept User Manual

Concept
User manual

3. Set up

The set up of the Concept - turntable is easy as the turntable and tonearm are pre-
assembled. If you chose the model with included cartridge, it has been mounted and all
parameters have been already adjusted and tested at the clearaudio factory. If not, refer
the section 4 on cartridge mounting and tonearm adjustment.
The Concept - turntable requires a place for set-up of at least 17 inch x 14 inch.
1.)
Please take first the Concept - turntable chassis out of the package and place it on a
suitable surface. After that please take the accessory box out of the package.
2.)
Please remove the adhesive security tape from the sub-platter.
Pic. 2: Removing the security tape
3.)
Take the drive belt out of the accessory box and place it around the sub-platter and around
the motor pulley.
4.)
Take the platter out of the package and place it carefully with both hands onto the shaft.
Pic. 3: Set up of the platter
5.)
Now remove carefully the adhesive security tape
from the tonearm and the cartridge (optional).
Pic. 4: Removing the tapes
Page 4  clearaudio electronic GmbH 2010