Set-Up And Operation - Clearaudio Smart Matrix Professional User Manual

3. Set-up and operation

3.1
Smart Matrix Professional
Place the
The surface should be waterproof. Please make sure that the machine is positioned safely and securely.
TIP: We recommend keeping a towel near the machine to mop up any fluid spillage.
Please check that the microfiber strips are not worn out or dirty before each cleaning session as using worn
or dirty strips could damage to a record.
Dust and dirt can be removed with a toothbrush and rinsing under water.
To change the microfiber strips, peel them off the vacuum arm and carefully clean the tube with an alcohol
based cleaning fluid. Remove the protective backing from the spare microfiber strip to expose the glue and
stick them alongside the suction slot of the vacuum arm. Please take care not to obstruct the suction slot
with the microfiber strips.
Smart Matrix Professional
The
adhesive takes 24 hours to fully cure. If used too soon the strips may not hold properly to the vacuum arm
and could damage your records.
Pic. 4: Changing microfiber strips
Pic. 5: Vacuum arm installation
Page /Seite 6
Smart Matrix Professional
machine on a clean, dry and stable surface.
should not be used for 24 hours after changing the microfiber strips. The
IMPORTANT:
Always check the microfiber strips before use.
Heavily soiled or worn strips can damage your records.
TIP: Microfiber strip lifespan is dependent on use. If
you are cleaning a lot of very dirty records you should
change the strips every 200 record sides.
Take the vacuum arm (Pic. 5) and insert it into the hole at the
front left hand side of the machine. Pay attention that the two
pins on the vacuum arm are aligned with the two cut outs in
the machine.
Push the vacuum arm down until it is fully inserted.
To remove the vacuum arm, pull it carefully upwards.
Bedienungsanleitung
© clearaudio electronic GmbH 2017
User manaul