Tt2 Set Up - Clearaudio TT2 User Manual

User manual / Bedienungsanleitung
Mounting the tonearm base on a turntable of other manufacturers:
In order to mount the tonearm base on the turntable chassis please first drill three holes into the
turntable chassis. To find out the right position of these drills please take the measurements out of
the drawing template (see picture below). For this step use a 3.3 mm drill. After you have drilled the
three holes, cut the windings with a proper screw-tap. If the material of the turntable chassis is not
suitable to be fitted with windings please use a 4.5 mm drill for the holes. In this case you will need
some longer screws with nuts to fix the tonearm base.
Now you can mount the tonearm base on the clean and dry surface of the turntable chassis.
Pic. 4: Drilling template
TT2
3. set up
For the next steps please remove the foam, that is used for transportation safety of the tonearm
carriage.
Pic. 5: Placing the tonearm on the tonearm base
6
To place the tonearm it is required that the two rods of the
tonearm base are in vertical position. To achieve this,
please pull out the small pivot on the side of the tonearm
base and pull the two rods in the vertical position. Now
you can slide the tonearm with its two precise drills onto
the two rods of the base. Do this until the threaded bolt
in the middle between the two drills of the tonearm fully
rests in the drilling of the tonearm base.
© clearaudio electronic GmbH, 2017/11