Link By Contact - Datalogic PowerScan BT8300 Family Quick Reference Manual

Link by Contact

Read the bar codes in sequence as shown in the steps below:
5. Firmly position the reader onto the cradle. The BC 8030-BT cradle will
emit a beep and the yellow LED will blink while the cradle is trying to
establish the connection.
Four ascending beeps will be emitted, signaling that the BC 8030-BT cra-
dle has been successfully connected to the PowerScan BT8300, and the
yellow LED on the cradle will stop blinking.
6. To connect another PowerScan PBT8300 to the BC 8030-BT cradle,
repeat the sequence from steps 1 through 5. One Cradle can connect with
a maximum of four readers.
7. Upon completing the connection between the reader and cradle you must
set up the correct interface for your system. Refer to the BC 8030-BT Base
Station Charger QRG for information and programming labels, and scan
the appropriate bar code to select your system's interface type.
END of procedure. YOUR READER IS NOW READY TO READ CODES.
Quick Reference Guide
1.
2.
3.
4.
Connecting the PowerScan BT8300
Enter Configuration
Handheld - Cradle
Link by Contact
Exit and Save Configuration
11