Before You Begin; Unpairing The Reader; Linking The Powerscan™ Bt8300 To The Bc 8030-Bt Cradle - Datalogic PowerScan BT8300 Family Quick Reference Manual

Connecting the PowerScan BT8300

Before You Begin

In order to use the connection procedures below, the handheld and base station
must be in an UNPAIRED state. If the reader is connected to a device, you must
follow the procedure below to UNPAIR the Base Station and the handheld before
attempting to link to a new device. If the handheld is not already connected to
another device, then you can skip this step and go straight to the Linking
instructions that begin on the next page.

Unpairing the Reader

To unpair the PowerScan BT8300 reader from a BC 8030-BT base station, press
and hold the button on the BC 8030-BT (>8 seconds), then read the Unpair bar
code below with each PowerScan BT8300 which you want to unpair from the
cradle.
You can Unpair the PowerScan BT8300 reader from a Bluetooth-Enabled PC to
make it available for pairing with another PC. Read the bar code above to
disconnect the reader from its PC
Please note that in order to connect different scanners to a Base that is already
connected to the maximum four scanners, you must follow the procedure above.
Linking the PowerScan™ BT8300 to the BC 8030-BT Cradle
The PowerScan BT 8300 reader can be connected with the PowerScan BC 8030-
BT cradle in either of three ways.
After the BC-8030-BT cradle is powered on and connected to the Host, configure
the Power Scan BT8300 by reading the following bar codes in the given sequence
as described in each section.
10
Remember: The mandatory condition for establishing a new
connection between a BT reader and a BT cradle is that they
share the same security configuration. The connection timeout
is 30 seconds. Four ascending beeps from the reader indicate a
successful link, otherwise there are four descending tones.
Unpair
PowerScan™ BT8300