Important Notice - Teleco Magic Sat 2002A Installation Manual

V006

IMPORTANT NOTICE

1) Due to transport reasons, Magic Sat 2002A comes packaged in two separate cartons
a) The first item contains the driving unit with all the cables and the control unit.
b) the second item only contains the dish.
It is essential to check that the dish has not been damaged during transport when the
package is opened. In particular, check the following well:
• By resting the dish edge against a flat surface (e.g. the floor or a wall) check that it
makes contact to the surface all around. If it is not so, try and make the edge level, without
denting the dish, or call our After-Sales
• After checking that everything is in order, install the dish on the driving unit as follows:
1) Temporarily connect the Control unit to the driving unit through the grey motor cable
2) Power both the Control unit and the receiver using a battery
3) Press the Red button in the remote control and extend the dish support mast
4) Press the " STOP " button in the remote control to lock the mast in a vertical position.
5) Secure the dish to the mast and screw down the four supplied screws
6) Press the " DOWN " button in the remote control and lower the antenna
7) Disconnect the Control unit, the battery and install Magic Sat 2002A on the vehicle
Pag. 4