Canon iPF8000 series Service Manual page 278

Chapter 8
Display massage
Hardware error.
03800500-2F30
Turn off printer, wait, then
turn on again.
Roll printing is selected.
Sheet printing is selected.
Borderless printng not
possible. Check supported
paper.
Borderless printng not
possible. Check roll
position.
PaprWidth Mismatch.
PaprWidth Mismatch.
Paper mismatch
Make sure media type and
paper size match for the
adjustment print.
Hardware error.
03130000-2E21
Turn off printer, wait, then
turn on again.
Cannot calibrate.
Press OK and try
calibration again.
Calibration
There is a problem
with the
multi-sensor.
Press OK to cancel
calibration.
8-14
Code*
03800500-2F30 Detectable area failure (when adjusting the position of
non-discharging nozzle)
The gap of detection position of nozzle both ends is
big.
03060A00-2E33 Roll media is not loaded when receiving the printing
job.
03060A00-2E37 Roll media is not loaded when printing.
03060100-2E05 Cut sheet is not loaded when receiving the printing
job.
03060100-2E02 Cut sheet is not loaded when printing.
03864004-240A Borderless printing disabled (unsupported size, when
pressing the Load button)
03864004-2409 Paper loaded at a position inaccessible for borderless
printing
03063000-2E08 Roll media width mismatch
03864001-2E45 Roll media width mismatch (when pressing the Load
button)
03060000-2E20 Cut sheet type or size is not match when printing the
printhead registration.
03863000-2826 Eccentricity correction error
03863000-282A Carriage motor rotation adjustment error
03863000-282B Carriage motor rotation adjustment error (when
detecting the vibration)
03130000-2E21 IEEE1394 port error
03863000-2F34 Color calibration adjustment failure error
03130031-2F35 Color calibration disabled
Condition detected Action
Check the ink tube unit and surrounding parts.
Check the purge unit and surrounding parts.
Check the head management sensor and
surrounding parts..
Check the flexible cable unit and surrounding parts.
Check that the printhead is attached correctly.
Replace the main controller PCB.
Replace the printhead.
Replace the carriage unit.
Set the roll media.
Set the roll media.
Set the cut sheet.
Set the cut sheet.
Check the media size.
Change the media size.
Check to see if a borderless printing spacer is
installed.
Reload the paper.
Change the roll media.
Change the roll media.
Change the cut sheet.
Check to see if paper has not jammed.
Check the carriage unit and surrounding parts.
Replace the carriage motor.
Check the carriage unit and surrounding parts.
Replace the carriage motor.
Check the IEEE1394 board is attached correctly.
Replace the IEEE1394 board.
Replace the main controller PCB.
Check the environment for interferences from
outside light.
Replace the multi sensor unit.
Check the parts counter in service mode.
Replace the multi sensor unit.