Canon iPF8000 series Service Manual page 139

2) Remove two screws [1] on front side of the printer and three screws [2] on the rear side, and then remove upper rear cover [3].
Note on installing the upper rear cover
1) Fit three rear-panel screws [1] into screw holes on the right side.
l) Upper cover
Removing the upper cover
1) To remove the upper cover, remove left/ right circle covers (L), left/ right circle covers (S), left/ right side covers , upper left/upper right covers, rear cover left/
right , right cover unit and upper rear cover.
2) Remove upper cover [2] while opening left/right arm stays [1] outward one by one.
m) Release lever
Removing the release lever
1) To remove release lever [1], remove the purge unit and then remove the release lever. To do so, keep pinch roller [2] pressurized to ease to work of phase align-
ment during gear installation.
[1]
[2]
[1]
[2]
[2]
[3]
[1]
F-4-20
[1] [1]
F-4-21
[2]
F-4-22
Chapter 4
[1]
4-11