Applying The Grease - Canon iPF8000 series Service Manual

4.4 Applying the Grease

4.4.1 Applying the Grease

Apply the grease at the location shown below.
Smear the grease lightly and evenly with a flat brush.
Don't apply the grease to locations other than those designated. Unwanted grease may cause poor print quality, take particular care that grease does not get onto the
wiper, cap, or the linear scale.
No. Place
1 The joint base rail and rib of carriage unit
2 Two feed roller backup
Bushing
3 Feed roller bearing
4 Pinch roller release cam three points x 10 parts
5 Upper cover stay shaft hole
The gear shaft of the upper cover stay gear
Upper cover stay shaft end
The gear tooth face of upper cover stay
1. The joint base rail [1] and the rib [2] of the carriage unit.
T-4-1
Kind Quantity
Molykote PG-641 Smear the grease lightly
Permalub G No.2 approx.12mg
Permalub G No.2 Smear the grease lightly
Permalub G No.2 approx.24mg
Permalub G No.2 Smear the grease lightly
Permalub G No.2 approx.24mg
Permalub G No.2 approx.24mg
Permalub G No.2 approx.24mg
Permalub G No.2 Smear the grease lightly
F-4-51
Note
Don't apply to central backup with bearing.
Apply if remove bearing from a feed roller.
[1]
[2]
Chapter 4
0014-9023
4-31