Canon iPF8000 series Service Manual page 116

Chapter 3
c-2. LEVEL 3
Moving the printer on its end
Item
[Prep. MovePrinter] on the Main menu Perform [LEVEL 3].
Allowed tilting angle
Ink consumption
Ink tank
Separation of main unit and stand
Maintenance cartridge
Replacement of consumable parts
Service support
Transportation procedure
1) If there is a message instructing to replace the maintenance cartridge or check the remaining ink, replace the maintenance cartridge.
2) Remove the paper and roll holder.
3) From [Set/Adj. Menu] > [Prep. MovePrinter], select [LEVEL 2] or [LEVEL 3].
4) Press the [OK] key and perform [LEVEL 2] or [LEVEL 3] MOVE PRINTER.
5) If the counter is checked and a message to replace consumable parts appear, check the consumable parts counter from service mode and replace the necessary
consumable part.
See "d. Replacing consumable parts during transportation."
Repeat [LEVEL 2] or [LEVEL 3] after replacing consumable parts and resetting the counter.
6) Follow the displayed message and open the left and right ink tank covers.
3-8
T-3-4
Lengthwise: -90 to +90 degrees
Rotation: -30 to +30 degrees
Approximately 1800ml of ink is consumed.
Remove all ink tanks.
Separate.
Replace with new maintenance cartridge before performing transporting procedure.
Three new maintenance cartridges must be provided.
(Two for disposing waste ink and one to be installed during transportation)
Replacement of consumable parts and resetting of counter may be necessary.
If consumable parts must be replaced, service support is necessary.
F-3-11
Description