Table of Contents
Advertisement
2) UGW Address [UGW-ADDRESS] and UGW port [UGW-PORT]
Usually, the default values set in advance are used for the setting value of [UGW-ADDRESS] and [UGW-PORT]. Unless there is a special instruction, the default
value should not be changed. If it should be changed, the communication with UGW may have an error. If [UGW-ADDRESS] and [UGW-PORT] are changed, the
new setting will be enabled after power OFF/ON.
Therefore, usually, the setup is not necessary.
* If you change under a special instruction, perform the following procedure.
(1) Setting address for UGW
- In service mode, referring to the "Service Mode Menu Tree", go to [UGW-ADDRESS] menu using
- Press
key to enter the Setup Mode. (A character indicating the input mode (in the upper right corner of the screen) and the cursor are displayed.)
Enter UGW address (URL).
Display to indicate an input mode
A:Alphabet capital letter
a:Alphabet small letter
1:Numerical character
- The cursor is shown at the first letter.
- Use
and
keys to select characters to enter.
- Press [Back] key to cancel what you entered and go back to the previous screen.
- Press [OK] key to determine what you entered and go back to the previous screen.
(2) Setting up the GW Port Number
- In service mode, referring to the "Service Mode Menu Tree", go to [UGW-PORT] menu using
- Press
key to enter the Setup Mode. (A cursor is displayed.)
Enter a port number.
- Use
and
keys to select characters to enter.
- Press [Back] key to cancel what you entered and go back to the previous screen.
- Press [OK] key to determine what you entered and go back to the previous screen.
* The actual setting value of UGW address [UGW-ADDRESS] and UGW port [UGW-PORT] are categorized as confidential information, so they are not described
in this manual.
3) Communication Test [COM-TEST]
(1) In service mode, referring to the "Service Mode Menu Tree", go to [COM-TEST] menu using
(2) Press [OK] key to start the test. ("=" is displayed at the start of the test.)
(3) During the communication test, "CHECK NOW" is displayed.
- Once the communication test is started, it cannot be cancelled.(Other operation won't be accepted until the result is obtained.)
E -
R D S
U G W
A D D R E S S
F-7-30
U G W
A D D R E S S
h t
t
p :
/
/
F-7-31
E -
R D S
U G W
P O R T
F-7-32
U G W
P O R T
F-7-33
C O M - T E S T
Y E S
F-7-34
C O M - T E S T
= Y E S
F-7-35
C O M - T E S T
C H E C K
N O W .
F-7-36
key and
key.
:
a
key and
key.
0 0 0 0 0
key and
key.
.
Chapter 7
7-31
Advertisement
Table of Contents
Troubleshooting
