Arctic Cat ZR 120 Service Manual page 54

5. Tighten the upper and lower retainer cap screws
securely.

NOTE: Check all fasteners to ensure they are tight.
Turn the handlebar full-left and full-right several times
to ensure free movement.
6. Apply Handlebar Adhesive to the bore of the han-
dlebar grip; then using a rubber hammer, drive the
grip into position.
! WARNING
The handlebar adhesive is extremely flammable. This
product contains acetone. The vapors released can be
easily ignited. Keep away from heat, sparks, and open
flame. Use only in a well ventilated area. Avoid pro-
longed breathing of vapor. Avoid eye and skin contact.
Keep container closed when not in use.
7. Place the emergency stop switch onto the right
handlebar and secure with the screw.
8. Route the throttle cable through the slot in the
throttle control and insert the cable end into the
throttle control. Secure the cable with a C-clip.
9. Seat each cable drum into its lever recess; then
secure each with a pin and C-clip.
A026
A981
A982
A980
A999
A979
51