Arctic Cat ZR 120 Service Manual page 12

4. Remove the two springs from the governor arm,
throttle cable bracket, and retaining bracket.

NOTE: For assembling purposes, note the location of
the governor arm spring before removing.
5. Remove the throttle cable and retaining brackets
from the engine.
6. Loosen the governor arm cap screw and remove
the arm; then disconnect the rod and spring from
the carburetor.
7. Slide the intake tube and carburetor off the mount-
ing studs. Account for three gaskets and an insula-
tor block.

NOTE: If the cylinder head will be replaced, the carbu-
retor studs may be removed by tightening the two nuts
IO065A
against each other; then using a wrench on the inside
nut, remove the stud.
8. Remove the recoil starter/fan housing assembly.
9. Remove the spark plug wire from the spark plug
and remove the spark plug; then remove the cap
screws securing the ignition coil to the crankcase
housing and remove the coil.
IO066A
10. Remove the cylinder head cover; then remove the
air shroud.
IO067A
11. Remove the air breather body from the cylinder
head cover. Account for a gasket.
IO068
IO069A
IO070A
9