Arctic Cat ZR 120 Service Manual page 34

3. Remove the C-clip securing the cable in the throt-
tle control; then remove the cable from the throttle
control.
4. Remove the handlebar pad and cut the cable tie
securing the throttle cable to the steering post.

NOTE: Note the location of the cable tie for assembly.
5. Rotate the throttle cable lever of the governor con-
trol arm to the wide-open position and route the
cable end out of the arm; then loosen the throttle
cable jam nuts and remove the throttle cable.
6. Inspect the throttle cable for damage or fraying.
INSTALLING
1. Route the cable through the slot in the throttle con-
trol and insert the cable into the throttle control.
Secure the cable with a C-clip.
A981
2. Seat the cable drum into the throttle lever recess;
then secure the throttle lever to the throttle control
with a pin and C-clip.
A982
3. Place the throttle cable into the throttle cable
bracket and secure with jam nuts.
4. Slide the end of the throttle cable into the throttle
cable lever.
5. Secure the throttle cable to the steering post with a
cable tie; then install the handlebar pad.
6. Open and close the throttle lever to make sure of
no binding or sticking.

NOTE: At this point, adjust the throttle cable (see
Throttle Cable in the Carburetor sub-section).
ADJUSTING
To adjust the throttle cable, see Carburetor – ADJUST-
0744-922
ING sub-section.
A981
A980
31