Arctic Cat ZR 120 Service Manual page 25

20. Rotate the flywheel until the magnet of the fly-
wheel is under the legs of the ignition coil; then
insert a flat 0.020" feeler gauge between the lower
leg of the coil and the flywheel.
21. Loosen the ignition coil mounting cap screws
(from step 16) enough to allow the coil to draw
against the feeler gauge. Tighten the cap screw
enough to hold the position of the coil; then repeat
the procedure for the other cap screw when an air
gap of 0.015-0.023" is obtained. Tighten the coil
cap screws to 120 in.-lb.
22. Install the recoil starter/fan housing assembly with
cap screws and tighten to 96 in.-lb.
23. Install the throttle cable mounting bracket and
secure the bracket with two cap screws to the
crankcase. Tighten to 120 in.-lb.
24. Install the carburetor (with a gasket, insulator
block, and a gasket) onto the mounting studs; then
install the rod and spring (A) onto the carburetor.
22
When performing service work on the fuel system, do
not smoke or allow open flames near the snowmobile.
IO099
25. Install the rod and spring into the governor control
arm and install the arm; then install the throttle
lever spring into the proper hole of the control arm
(as noted during disassembling) and the remaining
spring to the retaining bracket.
 NOTE: When securing the governor control shaft (A),
turn it clockwise until it stops; then tighten the control
arm cap screw (B) to 72 in.-lb.
IO100A
26. Install the gasket onto the mounting studs; then
install the intake tube to the carburetor. Tighten to
96 in.-lb.
IO105
! WARNING
IO102A
IO065A
IO067B