Installing The Printer Driver - Toshiba e-Studio16 Operator's Manual

INSTALLING THE PRINTER DRIVER

This section describes the installation of the printer drivers and the Status Display to Windows
95/98/Me/NT4.0/2000 or XP when your e-STUDIO16/20/25 is connected in local mode. If your
e-STUDIO16/20/25 is connected to a peer-to-peer type network or client server network, see the
"OPERATOR'S MANUAL FOR PRINTER FUNCTION - Network Setup".
SUPPLEMENTS:
G This manual describes settings for Windows 95. The setting details are similar for
Windows 98, Windows Me, Widnows NT, Windows 2000, and Windows XP.
G To install the printer driver to Windows NT 4.0, Windows 2000, or Windows XP, "Full
Control" access rights will be necessary. A log on must be performed as a member of
Administrators or Power Users group. For further details on access rights, see the
Windows manual.
NOTE:
G Before installing the printer drivers and TOSHIBA Status Display, please be sure to exit
all programs.
G When your e-STUDIO16/20/25 is connected in local mode, the Windows Plug-and-Play
function automatically starts the installation of the device driver in some environments.
You can install the printer drivers by following this function as well as through the
Windows Add Printer prompts. However, it is highly recommended that you select
cancel at all prompts and install from the CD-ROM. This will ensure that all printer
drivers and TOSHIBA Status Display components are installed at the same time.
1
Insert the CD-ROM into the CD-ROM
drive.
G The menu screen appears.
G If the menu screen is not automatically
displayed, or when the printer drivers and the
TOSHIBA Status Display is installed via the
network, double-click
STUDIO16_20_25.exe" in the Menu folder of the
CD-ROM, that may be found in Windows
Explorer.
2
Click on a language of your Operating
System.
Installing the Printer Driver
on "TOSHIBA_e-
11