3.7 Checking the installation
Check the loop signal by inspecting the LED
indicators on the charging station.
•
Steady green light = good signals.
•
Flashing blue light = interruption in the boundary
wire, no signal.
•
Flashing yellow light = interruption in the guide
wire, no guide signal.
•
Flashing red light = interruption in the charging
station's antenna plate, no remote signal
available. The fault should be rectified by an
authorized dealer.
•
Steady blue light = weak signal. This may
depend on the boundary wire being over 250 m in
length or that the wire is damaged. If the mower
still works, this is not a problem.
•
Steady red light = fault in a circuit board in the
charging station. The fault should be rectified by
an authorized dealer.
3.8 Linking Automower
charging station
1.
Set the main switch to the 1 position.
2.
Place Automower
®
3.
Open the control panel cover by pressing the
STOP button.
A start-up sequence begins when Automower
started for the first time. The following is requested:
•
Language
•
Time format
•
Correct time
•
Date format
•
Date
•
Four-digit PIN code. All combinations except 0000
are permitted.
3. INSTALLATION
®
305 to the
305 in the charging station.
®
305 is
English - 29