Connecting The Boundary Wire - Husqvarna Automower 305 Operator's Manual

3.5 Connecting the boundary wire

Connect the boundary wire to the charging station:
IMPORTANT INFORMATION
The boundary wire must not be crossed when
connecting to the charging station. Therefore
the right hand wire end must be connected to
the right hand connector on the charging
station and vice versa.
1. Place the cable ends in the connector:
• Open the connector.
• Place the wire in the connector grip.
2. Press the connector together using a pair of
pliers. Press until you hear a click.
3. Cut off any surplus boundary wire. Cut 1 - 2 cm
above respective connectors.
4. Press the connector onto the contact pin,
marked A, on the charging station.
IMPORTANT INFORMATION
The right hand connector should be
connected on the right hand contact pin on
the charging station and vice versa.
3. INSTALLATION
English - 25