TOOLS AND SUPPLIES REQUIRED
Phillips screwdriver
Flat-tip screwdriver
10 mm Combination wrench
Ratchet
10 mm Socket
File
Utility knife
Scissors
Shop towel
Hook tool
Masking tape
Tape measure
INSTALLATION
Customer Information: The information in this
installation instruction is intended for use only by
skilled technicians who have the proper tools,
equipment, and training to correctly and safely add
equipment to your car. These procedures should not
be attempted by "do-it-yourselfers."
1.
Make sure you have the anti-theft code for the
radio, then write down the frequencies for the
preset buttons.
2.
Disconnect the negative cable from the battery.
3.
Remove the trim ring.
M/T Model
•
Squeeze the plastic clip and pull down on the
shift boot. Remove the shift knob by turning it
counterclockwise.
SHIFT
KNOB
PLASTIC
CLIP
© 2002 American Honda Motor Co., Inc - All Rights Reserved.
SHIFT BOOT
2206031K
TRIM RING
•
Gently pry up on the trim ring to release the six
clips.
•
Unplug the two seat heater connectors
(if equipped), and remove the trim ring.
CLIPS (4)
TRIM
RING
A/T Model
•
Gently pry up on the trim ring to release the
six clips.
•
Unplug the two seat heater connectors
(if equipped), and remove the trim ring.
CLIPS (4)
TRIM
RING
AII 24379 (0208)
CLIPS (2)
SEAT HEATER
CONNECTORS
2206041K
(If equipped)
CLIPS (2)
SEAT HEATER
2206112K
CONNECTOR
(If equipped)
3 of 9