Download Print this page
Honda 08A23-2E1-010 Installation Instructions Manual
Honda 08A23-2E1-010 Installation Instructions Manual

Honda 08A23-2E1-010 Installation Instructions Manual

For honda accord 4-door

Advertisement

Quick Links

INSTALLATION
INSTRUCTIONS
Attachment Kit
P/N 08B23-SDA-100A
i -VES harness
Subharness
DIN Harness
Room light harness
Room light gasket
Template
© 2002 American Honda Motor Co., Inc - All Rights Reserved.
Accessory
in-VEHICLE
ENTERTAINMENT SYSTEM
(WITH MOONROOF)
AII 24046 (0208)
Application
ACCORD
4-DOOR
Monitor bracket
2 Washer-screws, 5 x 16 mm
2 Washer-screws, 5 x 25 mm
5 Square-neck bolts
5 Flange nuts, 4 mm
16 Wire ties
Wire ties with clip
6 Cushion tapes
Publications No.
AII 24046
Issue Date
AUG 2002
1 of 20
08B23-SDA-1000-9A

Advertisement

loading

Summary of Contents for Honda 08A23-2E1-010

  • Page 1 5 Flange nuts, 4 mm 16 Wire ties Room light harness Wire ties with clip Room light gasket 6 Cushion tapes Template 1 of 20 © 2002 American Honda Motor Co., Inc - All Rights Reserved. AII 24046 (0208) 08B23-SDA-1000-9A...
  • Page 2 Right player subbracket Remote controller Player base-bracket 2 Headphones Player panel 5 Washer-screws, 5 x 8 mm Pocket 2 Screw caps Owner’s Manual 2 of 20 AII 24046 (0208) © 2002 American Honda Motor Co., Inc - All Rights Reserved.
  • Page 3 Make sure you have the anti-theft code for the radio, then write down the frequencies for the preset buttons. Disconnect the negative cable from the battery. 3 of 20 © 2002 American Honda Motor Co., Inc - All Rights Reserved. AII 24046 (0208)
  • Page 4 10. Using the utility knife, cut out the marked area of the headliner. Remove the template. FELT-TIP PEN 2326030T Remove the template from the headliner. 4 of 20 AII 24046 (0208) © 2002 American Honda Motor Co., Inc - All Rights Reserved.
  • Page 5 CLIP (2) holder. DASHBOARD COIN CENTER POCKET HOLDER SELF-TAPPING TRIM SCREW RING (Reuse.) SEAT HEATER CONNECTOR (If equipped.) 2206041K CLIPS (2) VEHICLE HARNESS 2206061K 5 of 20 © 2002 American Honda Motor Co., Inc - All Rights Reserved. AII 24046 (0208)
  • Page 6 14. Remove the right and left inner covers (one hook and one clip for each cover). CLIP LEFT INNER COVER RIGHT INNER COVER HOOK POCKET OPENING 2226010K 6 of 20 AII 24046 (0208) © 2002 American Honda Motor Co., Inc - All Rights Reserved.
  • Page 7 CENTER SELF-TAPPING CLIP DASHBOARD SCREW UPPER COVER HAZARD SWITCH CENTER PANEL BOLT CLIPS (5) 2506030T FLAT-TIP SCREWDRIVER 2730040T 7 of 20 © 2002 American Honda Motor Co., Inc - All Rights Reserved. AII 24046 (0208)
  • Page 8 (release the three retaining clips, one pin LEFT FRONT and one holder). DOOR SILL HOLDER FRONT RETAINING CLIPS (3) RETAINING TABS (2) 2131010T DRIVER’S DASHBOARD UNDER COVER 2705440T 8 of 20 AII 24046 (0208) © 2002 American Honda Motor Co., Inc - All Rights Reserved.
  • Page 9 ANCHOR COVER With SRS System Shown CLIP (Remove.) CLIPS (2) LEFT CENTER PILLAR UPPER LEFT FRONT ANCHOR BOLT PILLAR TRIM 2319030M WEATHERSTRIP 2304071M 9 of 20 © 2002 American Honda Motor Co., Inc - All Rights Reserved. AII 24046 (0208)
  • Page 10 31. Remove the two caps from the left front grab rail, and remove the grab rail (two bolts). VEHICLE CONNECTOR ROOF CONSOLE LEFT FRONT GRAB RAIL BOLT 2326090T BOLT 2301011M 10 of 20 AII 24046 (0208) © 2002 American Honda Motor Co., Inc - All Rights Reserved.
  • Page 11 -VES HARNESS LEFT FRONT PILLAR TRIM OPENING i -VES HARNESS SUNVISOR HOLDERS (2) FLAT-TIP SCREWDRIVER 2326210T 90° TERMINAL DASHBOARD LOWER COVER OPENING 2326202T 11 of 20 © 2002 American Honda Motor Co., Inc - All Rights Reserved. AII 24046 (0208)
  • Page 12 Pull the room light harness up through the rear interior light opening and out through the headliner opening. 12 of 20 AII 24046 (0208) © 2002 American Honda Motor Co., Inc - All Rights Reserved.
  • Page 13 CONSOLE RIGHT VEHICLE FRAME LENS SQUARE-NECK BOLTS (5) CLIP (Do not remove clip.) FRONT MASKING TAPE MONITOR GASKET SQUARE- 2326290T NECK BOLT 2326270T 13 of 20 © 2002 American Honda Motor Co., Inc - All Rights Reserved. AII 24046 (0208)
  • Page 14 51. Secure the i -VES harness to the vehicle harness with four wire ties in the areas shown. 14 of 20 AII 24046 (0208) © 2002 American Honda Motor Co., Inc - All Rights Reserved.
  • Page 15 Attach the cushion tape to the vehicle frame, and secure the connected 20-pin connectors to the vehicle frame with one wire tie. 15 of 20 © 2002 American Honda Motor Co., Inc - All Rights Reserved. AII 24046 (0208)
  • Page 16 5 x 8 mm PLAYER BASE- WASHER- BRACKET SCREW 2326382T 62. Plug the 90° DIN harness terminal into the FM modulator (Not the i -VES harness). 16 of 20 AII 24046 (0208) © 2002 American Honda Motor Co., Inc - All Rights Reserved.
  • Page 17 MASKING bracket upward. TAPE VEHICLE FRAME 6 mm FLANGE NUT VEHICLE FRAME 2506010T LEFT PLAYER SUBBRACKET RIGHT PLAYER SUBBRACKET 2306021T 17 of 20 © 2002 American Honda Motor Co., Inc - All Rights Reserved. AII 24046 (0208)
  • Page 18 BRACKET WASHER- PLAYER 2326420T SCREWS (4) RIGHT POCKET PLAYER 4 x 8 mm BRACKET 2306031T SELF-TAPPING 4 x 8 mm SCREW SELF-TAPPING SCREW 18 of 20 AII 24046 (0208) © 2002 American Honda Motor Co., Inc - All Rights Reserved.
  • Page 19 EPT sealer, and cut off the marked area from the player panel. 75. Attach the two grommet screws to the player panel. PLAYER PANEL GROMMET SCREW 2306131T 19 of 20 © 2002 American Honda Motor Co., Inc - All Rights Reserved. AII 24046 (0208)
  • Page 20 85. Pull up fully on the driver’s window switch to close the window completely, then hold the switch for 2 seconds. 86. Test the window AUTO function. 20 of 20 AII 24046 (0208) © 2002 American Honda Motor Co., Inc - All Rights Reserved.

This manual is also suitable for:

08b23-sda-100a08b06-sda-100