Advertisement
TOOLS AND SUPPLIES REQUIRED
10 mm Wrench
Clip remover
Piece of wire
Diagonal cutters
Tape measure
Utility knife
Scissors
Ratchet wrench
10 mm and 14 mm Sockets
Felt-tip pen
Drill
3 mm, 6 mm, 8 mm, and 10 mm Drill bits
Center punch
Duct tape
Masking tape
Touch-up paint
Eye protection (face shield, safety goggles, etc.)
Vinyl tape
Cardboard or shop towel
Illustration of the XM Radio System Installed on the
Vehicle
XM RADIO
ANTENNA
XM RADIO
UNIT
2 of 8
14-PIN
CONNECTOR
VEHICLE
3613030M
SUBHARNESS
INSTALLATION
Customer Information: The information in this
installation instruction is intended for use only by
skilled technicians who have the proper tools,
equipment, and training to correctly and safely add
equipment to your vehicle. These procedures should
not be attempted by "do-it-yourselfers."
1.
Make sure you have the anti-theft code for the
radio, then write down the radio station presets.
2.
Disconnect the negative cable from the battery.
3.
Open the trunk lid, and remove the tool tray.
Remove the three clips that secure the spare tire
cover, and remove the cover.
4.
Remove the anchor bolt and the spare tire.
ANCHOR
BOLT
SPARE TIRE
AII 38245 (0710)
VEHICLE
SUBHARNESS
14-PIN
CONNECTOR
XM RADIO UNIT
XM RADIO
ANTENNA
SPARE TIRE
COVER
©
2007 American Honda Motor Co., Inc. - All Rights Reserved.
3613040M
3 CLIPS
3626040M
Advertisement
