Advertisement
2 Flange nuts, 8 mm
Template
4 Screws, 4 x 10 mm
4 Plain-washers, 8 mm
2 Sponge pads
Owner's manual
TOOLS AND SUPPLIES REQUIRED
Phillips screwdriver
Flat-tip screwdriver
Ratchet
7 mm, 8 mm, 12 mm, 13 mm, and 14 mm Sockets
10 mm Deep socket
Torx bit (T25)
Torque wrench
Utility knife
Masking tape
Electrical tape
Shop towel
Scissors
Piece of wire about 3 ft long
Flat-tip pen
Illustration of the i-VES Installed on the Vehicle
VCP
MONITOR
CONSOLE
2 of 14
20-PIN CONNECTORS
VCP
CONSOLE
i-VES HARNESS
INSTALLATION
Customer Information: The information in this
installation instruction is intended for use only by
skilled technicians who have the proper tools,
equipment, and training to correctly and safely add
equipment to your vehicle. These procedures
should not be attempted by "do-it-yourselfers."
1.
If equipped, make sure you have the anti-theft
code for the radio, then write down the
frequencies for the preset buttons.
2.
Disconnect the negative cable from the battery.
3.
Get the roof template. Using scissors, cut out
the center of the roof template.
4.
Position the template on the headliner, and
secure it with masking tape. Mark the headliner
as indicated on the template with a felt-tip pen
(two places).
FRONT VENT
TEMPLATE
UTILITY
KNIFE
5.
Remove the template. Using a utility knife, cut
out the marked areas of the headliner. Remove
and discard the cut pieces of the headliner and
the insulation.
AII 22054 (0104)
Strip of
masking tape
Cut out the marked
area from the
headliner.
FELT-TIP PEN
© 2001 American Honda Motor Co., Inc - All Rights Reserved.
FRONT
VENT
Advertisement
