Honda 08B06-SDA-100 Installation Instructions Manual page 9
Cassette/mp3/in-dash cd player attachment for 2003 accord 2- and 4-door
Hide thumbs
Also See for 08B06-SDA-100:
- Installation instructions manual (9 pages) ,
- Installation instructions manual (20 pages)
Table of Contents
Advertisement
19. Measure and cut one EPT sealer in three pieces
using scissors.
EPT SEALER
PLAYER
(Cut off the
PANEL
marked area.)
8 mm
8 mm
EPT SEALER
2612010T
20. Clean the player panel with isopropyl alcohol
where the EPT sealers will attach. Attach the EPT
sealer to the player panel and cut off the excess
area from the player panel.
21. Insert the player panel clips into their latches, and
attach the player panel to the instrument panel
with the two self-tapping screws you removed in
step 5. Remove the masking tape.
CLIP
LATCH
PLAYER
PANEL
SELF TAPPING
SCREW
(Reused)
2306141T
22. Check that all wire harnesses are routed properly
and all connectors are plugged in.
23. Reconnect the negative cable to the battery.
24. Enter the customer’s radio anti-theft code, and
reset the radio station presets.
25. Set the clock.
26. Check the operation of the player according to the
its Owner’s Manual.
27. Put the player Owner’s Manual in the glove box.
28. Reinstall all removed parts.
NOTE: Whenever the battery is disconnected, the
driver’s window AUTO function is disabled.
29. Start the engine. Push down fully on the driver’s
window switch until the window is open.
30. Pull up on the driver’s window switch to close the
window completely, then hold the switch for 2
seconds.
31. Test the driver's window AUTO function.
Page 9
Advertisement
Table of Contents
