Alarm/Door Bell Operation; Power Fail Transfer Operation; System Voice Memo - iPECS 7016D User's Operation Manual

iPECS
7016D & 7024D Phone
• Dial the Station User Program code 42,
• Press old/ ave.
H S
8.5

Alarm/Door Bell Operation

The system can monitor external Alarm or Door Bell contacts.
As an Alarm monitor, should the external contact activate, you may
receive a unique Alarm Ring signal and LCD display. To restart the
monitor circuit, the external contacts must be deactivated and the
Alarm Ring signal terminated.
As a Door Bell, you may receive a unique Door Bell Ring (single tone
burst) each time the external contact is activated.
control a system contact to act as a Door Open contact.
OPERATION
To terminate the Alarm signal;
• Dial the Alarm Stop code 565.
To activate the Door Open contacts;
• Lift the handset,
• Dial Door Open code #* and contact number 1 to 4. Note contacts
3 & 4 are only available in the iPECS -300.
8.6

Power Fail Transfer Operation

When AC power to the system fails, back-up operation may be
provided with back-up batteries or Power Fail Transfer (PFT). When
battery back-up is provided the station will operate normally. When
PFT is implemented, an SLT is connected to a CO line by the system.
This SLT can be used as any normal SLT, providing service while
power is out.
8.7

System Voice Memo

The integrated Voice Store & Forward (VSF) module incorporates
several Voice Memos to provide the station users with general
information such as station number, date, time, and feature status.
Voice Memos are heard over the speaker of the iPECS Phone and
over the handset for SLTs.
For the Station Status Memo, the following items are reported. Note
only activated features are announced.
ICM Signaling Mode (Handsfree/Tone/Privacy)
User Operation Guide
36
You may also
Con for
viñetas
Con for
viñetas
Con for
viñetas