Installing An External Dat Tape Drive; Important Information Before You Start; Check The Drive's Scsi Id - Tandberg Data DAT 160 User Manual

3
Installing an external DAT
In this chapter:
• "Check the drive's SCSI
• "Connect the power
Please refer to
installing an internal DAT tape drive.

Important information before you start

An external DAT drive will operate using any voltage in the range 100–240
volts (0.7 A, 50-60 Hz). No adjustment is needed.
A power cord and a SCSI cable are provided with your DAT tape drive.

Check the drive's SCSI ID

Your DAT drive is shipped with a default SCSI ID of 3. Each device on the
SCSI bus must have a unique SCSI ID number. The drive can be assigned
any unused ID between 0 and 15. Do not use SCSI ID 7, which is reserved
for the SCSI controller. SCSI ID 0 is typically assigned to the boot disk and
should also not be used unless the tape drive is on a dedicated SCSI bus.
August 2009
ID" on page 25
cord" on page 28
"Installing an internal DAT tape
tape drive
drive" on page 17, if you are
#
25