Table of Contents
Advertisement
3
Installing an external DAT
In this chapter:
•
"Important information before you
•
"Connecting the power and USB
Please refer to
installing an internal DAT tape drive.
Important information before you start
An external DAT drive will operate using any voltage in the range 100–240
volts (0.7 A, 50-60 Hz). No adjustment is needed.
A power cord is provided with your DAT tape drive. The USB 2.0 cable is
already fitted to the tape drive, you cannot remove it.
The drive is not powered from the USB bus. It must be connected to the
mains power supply.
Connecting the power and USB cables
1.
Make sure that the drive is switched OFF (O side down). The power
switch is on the rear panel.
August 2009
cables" on page 19
"Installing an internal DAT tape
tape drive
start" on page 19
drive" on page 13, if you are
#
19
Advertisement
Table of Contents
Need help?
Do you have a question about the DAT 160 and is the answer not in the manual?
Questions and answers