Omron E4C-UDA Instruction Manual page 16

Keylock
Setting method
Switch to the RUN mode.
SET RUN
Hold down the UP key for more
than 3 seconds with the MODE
key pressed.
+
Press the MODE key and then
immediately press the UP key.
LOC ON
Initializing all Setting Data (initialization processing)
Setting method
Switch to the SET mode.
SET RUN
+
Hold down the UP and DOWN keys for
more than 3 seconds.
INIT NO?
When "YES?" is displayed,
press the MODE key.
INIT GOOD
The head type setting is not cleared even if all setting data is initialized.
Refer to "1. Setting the Head Type" in "6. Basic Settings."
The sub-display flashes twice,
and key entry is disabled.
Initialization is completed.
Cancel method
SET
+
LOC
Data is not
initialized.
NO?
Data is
initialized.
YES?
- 16 -
Switch to the RUN mode.
RUN
Hold down the UP key for more
than 3 seconds with the MODE
key pressed.
Press the MODE key and then
immediately press the UP key.
The sub-display flashes twice,
and key entry is enabled.
OFF