Omron E4C-UDA Instruction Manual page 10

2) Manual setting
Manually set the threshold value.
Operation
SET RUN
Switch to the RUN mode.
Display
4. Setting Banks
Switch the SET/RUN switch to SET and register by following the
procedure below.
Registration procedure
Main display:
The display returns to regular measurement.
Selecting bank information
Switch the SET/RUN switch to SET and select the bank
information by following the procedure below.
Selection procedure
Press the MODE key.
Selection is completed, and the display moves to [6-BR].
(Refer to "Function Transition Charts in "5. Function Overview.")
Set the threshold value by
the UP or DOWN key.
Increments the threshold value.
Decrements the threshold value.
Sensing distance
Threshold value
Sub-display:
SET
Main display: Sub-display:
After about 3 seconds, the display returns
to the display set in the display setup.
SET RUN
Select [6-BR] by the MODE key.
Select the desired bank No. (0 to 3) by the UP or DOWN key.
(In this example, bank 2 is selected.)
Switch the SET/RUN switch to RUN.
RUN
Select YES by the UP or DOWN key,
and then press the MODE key to complete registration.
Note: If you perform the following at this stage,
registration is canceled.
• Select NO and press the MODE key.
• Set the SET/RUN switch to SET without
pressing the MODE key.
SET RUN
Select [5-BS] by the MODE key.
Select the desired bank No. (0 to 3) by the UP or DOWN key.
(In this example, bank 2 is selected.)
SET
Registration is completed, and the display returns to regular measurement.
- 10 -
Switch the SET/RUN switch to RUN.
RUN