Problem
No Video (black screen)
No Video (one camera)
No Video (jumbled colors)
Fuzzy Image (one camera)
Bad video (one camera)
Wrong Language
Buttons do not work
Recorded Video Rolls
Tape Plays Only 4x4
Too Many Motion Alarms
Motion Not Detected
APPENDIX A -
TROUBLESHOOTING
Check
Check power connections
Check camera power and coaxial cable
Make certain the multiplexer is set correctly for your system
(NTSC or PAL)
Check camera focus
Check the loop through connector. If a cable is attached, make
certain it is connect to another video device on the other end.
Change the language in the Setup Menu
Unlock buttons in Setup Menu
Check VCR configuration in Setup Menu. Use the trigger pulse
from the multiplexer for optimum synchronization with a time-lapse
VCR.
Make certain the video cable to the VCR input is connected to the
VCR OUT of the multiplexer.
Adjust the sensitivity of the motion detection grid. Adjust size of
grid required to activate motion alarm. Make certain only the area
you want to detect motion is activated.
Adjust the sensitivity of the motion detection grid. Adjust size of
grid required to activate motion alarm. Make certain only the area
you want to detect motion is activated.
39
Need help?
Do you have a question about the 4, 9, &16-ChannelTalon Triplex Color Multiplexers and is the answer not in the manual?