Camera Picture Adjustment - ATV 4, 9, &16-ChannelTalon Triplex Color Multiplexers Installation And Operating Instructions Manual

4, 9, & 16-channel talon triplex color multiplexers
Table of Contents

Advertisement

Recording Index Setup
Normally the multiplexer gives the same priority to all cameras. However, you can set the
recording index to give higher priority to specific cameras.
The screen shown above is used to set the priority of each camera for recording (up to 128
index positions).
The + and – options increment and decrement the camera number displayed in the box
centered between the two. The < and > arrows scroll through the camera array left to right.
Delete: The Delete option deletes the highlighted camera from the array.
Insert: The Insert option inserts a blank into the array.
End: The End option inserts an "E" into the array which set the end mark for the index
list.
View: The View option displays the Motion Detection Index List as shown in the
following figure.

Camera Picture Adjustment

The Camera Picture Adjustment screen is used to individually adjust the Contrast,
Brightness, Tint, Color, and Sharpness of each of the cameras. It is recommended that no
adjustments be made using this option until the actual cameras and monitors have been
adjusted.
The center window displays the camera view selected for adjustment. To move backward or
forward one camera position, use the < and > options under the center display window. To
move to the beginning or end of the camera list, use the << and >> options.
29

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 4, 9, &16-ChannelTalon Triplex Color Multiplexers and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

Talon 4Talon 9Talon 16

Table of Contents