Installing The I/O Panel - Dell Dimension 9200C Service Manual

Removing and Installing Parts: Dell Dimension 9200C Service Manual
1 screw
8. Remove the Diagnostic LED card.
a. Remove the cable connected to the card.
b. Press the Diagnostic LED card case release lever and slide the case towards the bottom of the chassis to release
the card case from the chassis.
c. Gently remove the LED card case from the computer.

Installing the I/O Panel

CAUTION: When reinstalling the fan, ensure that you do not pinch the wires that run between the system
board and the fan.
Follow the procedures in
To replace the Diagnostic LED card:
1. Orient the five LED card case tabs with the slots in the chassis.
NOTE: Ensure that the card release lever is on top.
2. Press the case so that the tabs fix firmly into the slots in the chassis.
3. Press the LED card case release lever and slide the case towards the top of the chassis until you hear a click and the
case locks in position.
4. Replace the cable connected to the card.
file:///T|/htdocs/systems/dim9200C/en/SM_EN/parts.htm[10/31/2012 8:07:53 AM]
2 front I/O panel
Removing the Front I/O Panel in reverse order.