Removing A Media Card Reader - Dell Dimension 9200C Service Manual

Removing and Installing Parts: Dell Dimension 9200C Service Manual
7. Replace the computer cover (see
NOTICE: To connect a network cable, first plug the cable in to the network port or device, and then plug it in to the
computer.
8. Connect your computer and devices to electrical outlets, and then turn them on.
See the documentation that came with the drive for instructions on installing any software required for drive operation.
9. Enter System Setup (see
Media Card Reader
For information about using the Media Card Reader, see your Owner's Manual.
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the
Product Information Guide.
NOTICE: To prevent static damage to components inside your computer, discharge static electricity from your body
before you touch any of your computer's electronic components. You can do so by touching an unpainted metal surface
on the computer chassis.

Removing a Media Card Reader

1. Follow the procedures in
2. Remove the CD/DVD drive, if installed (see
3. Remove the hard drive (see
4. Disconnect the interface cable from the back of the Media Card Reader and from the Media Card Reader connector on
the system board (see
1 interface cable
5. Pull up on the drive release latch and slide the Media Card Reader towards the back of the computer, then lift to
remove the drive from the computer.
file:///T|/htdocs/systems/dim9200C/en/SM_EN/parts.htm[10/31/2012 8:07:53 AM]
Replacing the Computer
Entering System Setup), and then select the appropriate Drive option.
Before You Begin.
Removing a CD/DVD
Removing a Hard Drive).
System Board Components).
2 Media Card Reader connector
Cover).
Drive).