Table of Contents
Advertisement
Removing and Installing Parts: Dell Dimension 9200C Service Manual
1
data cable
4. Connect the data cable to the CD/DVD connector on the system board.
5. Gently position the drive until it clicks into place.
1
CD/DVD drive
6. Check all cable connections, and fold cables out of the way to provide airflow for the fan and cooling vents.
7. Replace the computer cover (see
8. Connect your computer and devices to electrical outlets, and then turn them on.
9. See the documentation that came with the drive for instructions on installing any software required for drive operation.
10. Enter System Setup (see
Floppy Drive (Optional)
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the
Product Information Guide.
CAUTION:
To guard against electrical shock, always unplug your computer from the electrical outlet before
removing the cover.
Removing a Floppy Drive
1. Follow the procedures in
2. Remove the CD/DVD drive, if installed (see
3. Pull up on the drive release latch and slide the floppy drive towards the back of the computer.
4. Carefully, lift the drive away from the computer.
file:///T|/htdocs/systems/dim9200C/en/SM_EN/parts.htm[10/31/2012 8:07:53 AM]
2
power cable
2
CD/DVD drive bracket
Replacing the Computer
Entering System
Setup), and then select the appropriate Drive option.
Before You
Begin.
Removing a CD/DVD
3
CD/DVD connector
Cover).
Drive).
Advertisement
Table of Contents
