Installing The Input/Output (I/O) Panel; Removing The Power Supply - Dell OptiPlex XE2 Small Form Factor Owner's Manual

Installing the Input/Output (I/O) Panel

1. Insert the I/O panel into the slot on the chassis front.
2. Slide the I/O panel to secure it to the chassis.
3. Tighten the screw to secure the I/O panel to the chassis.
4. Connect the I/O panel or FlyWire cable and audio cable to the system board.
5. Thread the I/O panel or FlyWire cable into the fan-shelter clip.
6. Install the:
a. drive cage
b. optical drive
c. front bezell
d. cover
7. Follow the procedure in

Removing the power supply

1. Follow the procedure in
2. Remove the:
a. cover
b. front bezel
c. optical drive
d. drive cage
3. Disconnect the 8-pin power cables from the system board.
4. Disconnect the 4–pin power cables from the system board.
After working inside your computer.
Before working inside your computer.
25