Installing The Input/Output (I/O) Panel - Dell OptiPlex 3010 Small Form Factor Owner's Manual

8. Slide the I/O panel towards the right of the computer to release it from the chassis.
9. Remove the I/O panel.
Related Links

Installing The Input/Output (I/O) Panel

Installing The Input/Output (I/O) Panel
1. Insert the I/O panel into the slot on the chassis front.
2. Slide the I/O panel towards the left of the computer to secure to the chassis.
3. Tighten the screw to secure the I/O panel to the chassis.
4. Connect the I/O panel or the FlyWire cable to the system board.
5. Thread the I/O panel or the FlyWire cable into the fan-shelter clip and the routing on the heat sink.
6. Install the drive cage.
7. Install the front bezel.
8. Install the cover.
9. Follow the procedures in After Working Inside Your Computer.
25