Arris Touchstone TG952 User Manual page 20

Getting
Safety Started
Ethernet
Installation Configuration
Instructions
Wall-mounting instructions
Note: When mounting the Telephony Gateway on drywall, try to position the
Telephony Gateway so at least one of the screws is fastened to a stud.
This may prevent the Telephony Gateway from pulling out of the wall in
the future. To prevent overheating of the Telephony Gateway, do not
block the ventilation holes on the sides of the unit.
1 Position the mounting template on the surface where you intend to mount
the Telephony Gateway and secure in place with transparent tape.
2 Drill holes through the template in the specified locations for the mounting
screws. After drilling holes, remove the template from the surface.
3 If using drywall anchors, set them into the wall. Then, drive the screws into
the wall leaving a gap of about 1/8" (3 mm) between the screw head and
the wall. If not using anchors, just drive the screws.
4 Orient the Telephony Gateway with the indicator lights facing up or right, as
desired. Slip both mounting slots (in the back of the Telephony Gateway)
over the screws, then slide the case down until the narrow end of the key-
hole slot contacts the screw shaft.
5 Proceed to
Desktop mounting instructions
1 Position the Telephony Gateway so that:
• air flows freely around it
• the back faces the nearest wall
• it will not fall to the floor if bumped or moved
• the ventilation holes on the side of the unit are not blocked.
2 Proceed to
Touchstone TG952 Telephony Gateway User's Guide
Usage Troubleshooting
Connecting the Telephony Gateway.
Connecting the Telephony Gateway.
Glossary
20