2100Sc & 2200Sr Convertible Top (If Equipped) - Maxum 2200SR3 Owner's Manual

2100SC & 2200SR Convertible Top (If Equipped)
NOTE: 2100SC TOP PICTURED.
2200SR TOP SIMILAR.
A
G
C
D
SWIVEL END
Installing the Convertible Top
1. Slide the swivel ends of the main bow (A) over the pre-drilled hole on each side windshield frame (B) and secure
with the attached pins.
2. Hook the hold down straps (C) into the deck loops (D).
3. Unfold the canvas top and pull the secondary bow (E) and the canvas forward.
4. Open the center windshield panel and stand in the opening.
5. Snap the snaps (F) on each side of the zipper to the first two snaps on the starboard windshield frame.
6. Snap the forward edge canvas snaps to the port and starboard windshield frames.
7. Carefully close the center windshield panel and snap the remaining snaps to the center windshield frame.
8. Align the secondary bow (E) with the center seam of the canvas by loosening or tightening the top straps
(not pictured).
9. No adjustments to the jaw slides (G) should be needed as they are preset during manufacturing. If you decide to
adjust the jaw slide positions, obtain the correct measurements from your selling dealer.
10. If additional canvas (i.e. side curtains or slant back cover) is installed, the canvas top may need readjustment to
align the snaps on the canvas with the snaps on the boat.
E B
SECURING PIN
Chapter 7: Deck Equipment
F
33