1800Sr3 & 2000Sr3 Convertible Top (If Equipped) - Maxum 2200SR3 Owner's Manual

Chapter 7: Deck Equipment
1800SR3 & 2000SR3 Convertible Top (If Equipped)
C
Installing the Convertible Top
1. Slide the swivel ends of the main bow (A) over the pre-drilled hole on each side windshield frame (B) and secure
with the attached pins.
2. Insert the end eyes of the aft braces (C) into the deck hinges and secure them with the spring-loaded pins.
3. Unfold the canvas top and pull the secondary bow (D) and the canvas forward.
4. Open the center windshield panel and stand in the opening.
5. Snap the snaps (E) on each side of the zipper to the first two snaps on the starboard windshield frame.
6. Snap the forward edge canvas snaps to the port and starboard windshield frames.
7. Carefully close the center windshield panel and snap the remaining snaps to the center windshield frame.
8. Align the secondary bow (D) with the center seam of the canvas by loosening or tightening the top straps
(not pictured).
9. No adjustments to the jaw slides (F) should be needed as they are preset during manufacturing. If you decide to
adjust the jaw slide positions, obtain the correct measurements from your selling dealer.
10. If additional canvas (i.e. side curtains or slant back cover) is installed, the canvas top may need readjustment to
align the snaps on the canvas with the snaps on the boat.
32
END EYE (TYPICAL)
SPRING LOADED SECURING PIN (TYPICAL)
HINGE (TYPICAL)
F D A B
E
SWIVEL HINGE
SECURING PIN (TYPICAL)