2100Sc & 2200Sr3 Convertible Top (If Equipped) - Maxum 1800MX Owner's Manual

Chapter 7: Deck Equipment
2100SC & 2200SR3 Convertible Top (If Equipped)
1. Slide the windshield
hinges of the main
bow (A) over the
pre-drilled hole on
each side wind-
shield frame (B)
and secure with the
attached pins.
2. Hook the hold down
straps (C) into the
deck loops (D).
3. Unfold the canvas
top and pull the sec-
ondary bow (E) and
the canvas forward.
4. Open the center
windshield panel
and stand in the
opening.
5. Snap the snaps (F)
on each side of the
zipper to the first
two snaps (G) on
the starboard wind-
shield frame.
6. Snap the forward
edge canvas snaps
to the port and star-
board windshield
frames.
7. Carefully close the center windshield panel and snap the remaining snaps to the center windshield frame.
8. Align the secondary bow (E) with the center seam of the canvas by loosening or tightening the top straps
(not pictured).
• The jaw slides (H) should not need to be adjusted.
• If you decide to adjust the jaw slide positions, obtain the correct measurements from your selling dealer.
• If other canvas (i.e. side curtains or slant back cover) is installed, the canvas top may need adjustment to align the
snaps on the canvas with the snaps on the boat.
58
NOTE: 2100SC TOP PICTURED. 2200SR3 TOP SIMILAR.
E
A
H
C
D
B
F
WINDSHIELD
HINGE
G
SECURING PIN