Indicator Light - Blue Seal E91 Service Manual

6.2.2 Selector switch
1) Remove the selector knob by pulling firmly
away from the control panel.
2) Undo the two screws at the bottom of the
control panel. Drop the control panel down to
access components.
3) Undo the two screws securing the selector
switch to the control panel.
Figure 6.2.2a
4) Transfer the wires to the new selector switch,
and secure to control panel with two screws.
5) Replace selector knob and control panel.
NOTE: Correct switch operation:
0 1
OFF
700W
Selector switch
Figure 6.2.2b
Blue Seal Evolution Series Electric Salamander
Revision 1/
Selector switch
securing screws
Control panel
screws
2 3
1900 3000
Service Procedures

6.2.3 Indicator light

1) Undo the two screws at the bottom of the
control panel. Drop the control panel down
to access components.
2) Remove the wires from the rear of the neon.
3) From rear push neon through front of panel
rotating clockwise.
4) Push new neon in from front of panel, and
reconnect wires.
5) Replace control panel.
11
6
© Moffat Ltd, January 2007