Table of Contents
Advertisement
Electrical Connection
T
HIS APPLIANCE MUST BE EARTHED
QUALIFIED PERSON IN ORDER TO AVOID A HAZARD
When connecting a Blue Seal electric appliance to the main supply, ensure that the following is
carried out:-
•
An isolating switch is fitted within 2 m of the appliance, but not on the appliance and in such a
position that the user does not have to reach across the cooking surface.
•
Supply cord shall be oil-resistant, sheathed flexible cable and not lighter than ordinary poly-
chloroprene or other equivalent synthetic elastomer sheathed cord (as per AS/NZS 3191 part
2.10.11. or IEC 60245-IEC-57) e.g. HO5 RN-F Type.
•
The branch supply line shall be individually overload protected to the correct current rating and
the supply chord shall be protected against any mechanical or thermal damage.
•
A grommet is fitted around the wiring entry hole into the appliance.
•
All wiring connections must be tight.
Refer to the appropriate wiring standards for the size of cable that is to be supplied to an appliance for
the current drawn on that line.
NOTE: ALL ELECTRICAL CONNECTIONS MUST ONLY BE CARRIED OUT BY AN AUTHORISED PER-
SON.
1.
Remove either the left or right hand side panel to allow access to the electrical connection terminal block.
Fit the cable through the small grommet located at the rear of the unit and connect to the terminals as
marked.
2.
If required, the appliance can be connected to two 13 or 15 amp single phase supplies by removing the
insulated wire loom between the left and right hand terminal blocks. Independent supplies can then be
connected to each side.
3.
The
operating
salamander is stated on the rating
plate affixed to the right hand side
panel front bottom corner. This in-
formation is also shown in the
"Specifications" Section of this man-
ual. Ensure that the available volt-
age is correct.
NOTE:
•
This appliance must be grounded / earthed.
•
Fixed wiring installations must incorporate an all-pole disconnection switch.
Commissioning
1.
Before leaving the new installation, check that all the connections are correct and, and that the unit func-
tions in accordance with the operating instructions.
2.
Check the current draw and loading for the equipment.
electrical requirements.
NOTE:
• •
If for some reason it is not possible to get the unit to operate correctly, turn off the elec-
trical power supply and contact a qualified service person. The supplier of this unit will be
able to recommend a suitable person.
•
Make sure that the electrical supply is turned off before any service or maintenance work
is carried out.
Blue Seal Evolution Series Electric Salamander
Revision 1/
WARNING:
. I
F THE SUPPLY CORD IS DAMAGED
.
voltage
of
the
,
IT MUST BE REPLACED BY A SUITABLY
Refer specification section for correct
5
2
Installation
Rating Plate
© Moffat Ltd, January 2007
Advertisement
Table of Contents
