Displaying The Color Bar; Adjusting The Camera Image - JVC GY-HM100U Instructions Manual

Displaying the Color Bar

Applicable to: Manual shooting mode M
Set to the Manual shooting mode.
Displays the color bar on the screen and starts recording in
this state. (See below)
There are two ways to display the color bar.
Set [COLOR BAR] in the [CAMERA PROCESS] menu to
[ON]. (A Page 61)
Set [USER1], [USER2], or [USER3] in the [CAMERA
SETTINGS] menu to [COLOR BAR], then press the
corresponding USER button.
Assignment of USER buttons: (A Page 21, 65)
● The color bar appears.
Memo :
● Between the two methods above, setting via the USER
button is given a higher priority.
● When in the Full Auto shooting mode, the color bar will not
appear.
Clearing the color bar display
Set the [COLOR BAR] menu to [OFF].
Alternatively, press the USER button that is set as
[COLOR BAR].
Recording the color bar
When the [SYSTEM SELECT], [REC MODE] menu is as
below, the color bar can be recorded.
SYSTEM SELECT
1080-60/30
1080-50/25
720-60/30 1280/60p(HQ), 1280/60p(SP)
720-50/25 1280/50p(HQ), 1280/50p(SP)
On-screen display on the external monitor
If the [SYSTEM SELECT] menu is set to [720-**], the on-
screen display will appear as usual when the color bar is
output on the external monitors below. ([DISPLAY ON TV]
setting in the [CONNECTION SETTINGS] menu is invalid.)
● A/V OUT terminal
● D1 (480i/576i) output of COMPONENT OUT terminal
● 480i/480p/576i/576p output of HDMI terminal
REC MODE
1920/60i(HQ), 1920/30p(HQ)
1920/50i(HQ), 1920/25p(HQ)
Adjusting the Camera
Image
Applicable to: Full Auto shooting mode A, Manual shooting
mode M
The picture quality of the camera can be set using the
[CAMERA PROCESS] menu.
Adjustment screens are displayed for the following items in
the [CAMERA PROCESS] menu.
As the adjustments are shown on the screen, you can adjust
the values while checking the picture quality on the camera.
DETAIL LEVEL
DETAIL V/H BALANCE
GAMMA LEVEL
COLOR GAIN
For details of the respective items, see the [CAMERA
PROCESS] menu. (A Page 59)
Example: DETAIL LEVEL
Detail Icon
1 .
Adjust accordingly.
Push the Set Lever to the left or right.
● Doing so moves the slide bar in the same direction. The
detail level of the camera image changes according to the
movement along the slide bar.
2 .
Confirm the adjusted value.
Press the center of the Set Lever.
● The menu screen closes.
Memo :
● When the setting values of the [GAMMA], [COLOR
MATRIX], and [KNEE] items in the [CAMERA PROCESS]
menu are altered, the change is reflected instantly on the
screen. (A Page 59)
0
Slide Bar
39