Adjusting The Exposure Manually; Using The Tele Macro Feature - JVC GY-HM100U Instructions Manual

Adjusting the Exposure
Manually
Applicable to: Full Auto shooting mode A, Manual shooting
mode M
Generally, the brightness of the subject that is being shot is
automatically adjusted according to the reference values of
the camera. However, the brighter or darker areas of an
image may appear unclear depending on the shooting
conditions. To prevent this from occurring, you can correct
the exposure manually.
1 .
Set to the Manual Exposure mode.
Press AE±.
● The AE value appears on the screen, and the adjustment
mode is enabled.
(Control using the EV value when in the still picture mode.)
AE
AE Value
± 0
2 .
Adjust the exposure.
Turn the ADJ./VOL. knob.
Turn upward to increase the value and make the image
brighter.
Turn downward to decrease the value and make the image
darker.
3 .
Confirm the setting value.
Press the ADJ./VOL. knob.
● The manual setting value is set. (The setting value (-6 to
+6) is displayed on the screen.)
4 .
After setting the value, press the ADJ./VOL. knob for
1 second or longer to switch to the AE Lock mode.
(An L mark appears after the setting value on the
screen.)
AE Lock: Locks the exposure setting value.
-6
AE Lock
Canceling AE Lock
Press the ADJ./VOL. knob for 1 second or longer.
● The mark disappears.
Disabling the Manual Exposure mode
● Press AE±.
AE
OPEN
AE±
CLOSE
ADJ./VOL.
Knob
Memo :
● AE Lock is canceled if the shutter speed or aperture is set
to the manual mode.
● When in the still picture mode, exposure cannot be
adjusted manually if shutter speed and aperture are set to
the manual mode. (The AE display flashes for about 5
seconds on the screen and its setting becomes invalid.)
Using the Tele Macro
Feature
Applicable to: Full Auto shooting mode A, Manual shooting
mode M
Shortens the closeup distance at the tele (T) end of the
zoom.
(1 m B approx. 80 cm)
There are two ways to set this feature.
Set [TELE MACRO] in the [CAMERA PROCESS] menu to
[ON].
(Possible only in Manual mode M)
(A Page 61)
Set [USER1], [USER2], or [USER3] in the [CAMERA
SETTINGS] menu to [TELE MACRO], then press the
corresponding USER button.
(Possible in Full Auto mode A and Manual mode M)
Assignment of USER buttons:(A Page 21, 65)
● When the tele macro feature is turned on, a tele macro
icon appears on the screen.
Tele Macro Icon
18dB
ND
Memo :
● Between the two methods above, setting via the USER
button is given a higher priority.
ACCESS
IRIS
SHUTTER
REC
AE ±
DC
33