Audio Input Signal Selection - JVC GY-DV550U Instruction Manual

6. SETTING AND ADJUSTMENTS BEFORE SHOOTING

6-9 Audio Input Signal Selection

VF
ZEBRA
OFF
SKIN
AUTO
ON
AREA WHITE
ACCU
FOCUS
VTR
AUDIO TAKE
LEVEL CH-1
AUDIO IN FRONT
connector
The GY-DV550 is provided with the AUDIO INPUT connector
on the front section and the AUDIO INPUT connectors at the
rear section for audio input.
Two channels of sound can be recorded on the tape in digital
PCM format.
Using the AUDIO INPUT switch, select for each channel (CH1
and CH2) whether the sound to be recorded should be the
sound from the AUDIO INPUT connector on the front section
or the sound from the AUDIO INPUT connectors on the rear
section.
Selecting the CH-1 channel input sound
Make the selection using the CH-1 AUDIO INPUT switch.
FRONT : The sound from the AUDIO INPUT connector on
the front section is recorded on the CH-1 channel.
REAR : The sound from the AUDIO INPUT connector on
the rear section is recorded on the CH-1 channel.
Selecting the CH-2 channel input sound
Make the selection using the CH-2 AUDIO INPUT switch.
FRONT : The sound from the AUDIO INPUT connector on
the front section is recorded on the CH-2 channel.
REAR : The sound from the AUDIO INPUT connector on
the rear section is recorded on the CH-2 channel.
50
OPERATE/WARNING
LIGHT
RESET ON
OFF
MONITOR
SELECT COUNTER
FILTER CH-1 CTL
ALARM
1 MIX TC
3200k
CH-2 UB
2 5600k+1/8ND
3 5600k+1/64ND
SHUTTER STATUS MONITOR
CH-1 CH-2 CH-1 CH-2
MENU AUTO FRONT
MANUAL REAR
AUDIO SELECT AUDIO INPUT
AUDIO
CH-1 CH-2
LEVEL
AUTO IRIS FULL AUTO BLACK LOLUX
BACK L STRETCH
NORMAL NORMAL
SPOT L COMPRESS
OPERATE
NG
ON OFF
CH-1 AUDIO CH-2 AUDIO
INPUT switch INPUT switch
CH-1 CH-2 CH-1 CH-2
AUTO FRONT
MANUAL REAR
AUDIO SELECT AUDIO INPUT
AUDIO
CH-1 CH-2
LEVEL
Selection of front audio input and rear audio input
connectors
Select the audio signal input to the AUDIO IN FRONT and
AUDIO IN REAR connector using the [LINE/MIC] switch.
Make settings for the AUDIO IN FRONT and AUDIO IN
REAR connectors separately.
LINE
MIC
MIC +48 V : Set to this position when a microphone
When connecting a component that does not require
+48 V power supply, make sure that the LINE/MIC switch
is not set to MIC +48V.
Neglecting this could cause damage to the connected
component.
MODE
RM
VTR
INCOM
MIC
CARBON
DYNAMIC
INCOM
MIC LEVEL
ON
AUDIO IN
OFF
CALL
REAR
RM OFF DC IN
/BATT.
LINE/MIC
POWER
switch
EARPHONE
DC
OUTPUT
: Set to this position when connected to audio
equipment, etc.
The reference input level is +4 dBs.
: Set to this position when using a monaural
microphone.
The reference input level is -60 dBs.
(phantom microphone) requiring +48 V DC
power supply is connected.
CAUTION:
AUDIO IN
FRONT
LINE/MIC
switch
DV INTERCOM
LINE MIC LINE MIC
+48V +48V
ON ON
FRONT DC INPUT
AUDIO IN
REAR
AUDIO
IN REAR
connector