Adapter Section - JVC GY-DV550U Instruction Manual

2. CONTROLS, INDICATORS AND CONNECTORS

2-5 Adapter Section

1
[POWER] power source setting switch
The power source to this unit is selected using this switch.
When turning on the power, set this switch first.
DC IN/BATT : Use this setting when supplying power from
the DC INPUT connector of this unit or from
the battery.
OFF : Use this setting when not supplying power to
this unit.
RM : Use this setting when supplying power from
the camera control unit through the VTR/RM
multi-pin connector 8 .
CAUTION:
When connecting an external VCR, set this switch to
DC IN/BATT and supply power from the DC INPUT
connector or the battery of this unit.
2
[CALL] button
This button is pressed when sending call signals to a camera
control unit operator without using the intercom headset.
When this button is held down, BACK TALLY lamp 7 blinks
and call signals are sent to the camera control unit. When
releasing this button, the unit stops sending the call signals
and BACK TALLY lamp 7 turns off.
3
[INCOM MIC] intercom microphone ON/OFF switch
Microphone ON/OFF switch for the intercom headset.
Set the switch to OFF when not using the microphone of
the headset.
4
[INTERCOM LEVEL] intercom receiver volume
Knob for controlling the intercom headset receiver volume.
5
[INCOM MIC] intercom microphone setting switch
This switch is used to select the microphone type of the
intercom headset.
20
RESET
MONITOR
SELECT
FILTER
CH-1
ALARM
MIX
1 3200k
CH-2
2 5600k+1/8ND
3 5600k+1/64ND
SHUTTER STATUS MONITOR
MENU
CH-1
AUTO IRIS FULL AUTO BLACK LOLUX
BACK L STRETCH
NORMAL NORMAL
SPOT L COMPRESS
OPERATE
NG
ON OFF
OPERATE/WARNING
LIGHT
MODE
ON
RM
OFF
VTR
INCOM
COUNTER
MIC
CTL
CARBON
TC
DYNAMIC
UB
INCOM
MIC
LEVEL
ON
CH-1 CH-2 CH-1 CH-2
AUTO FRONT
MANUAL REAR
AUDIO SELECT AUDIO INPUT
OFF
AUDIO
CH-2
LEVEL CALL
RM OFF
POWER
CARBON : Use this setting when using a carbon-type
microphone.
DYNAMIC : Use this setting when using a dynamic-type
microphone.
6
[MODE] setting switch
This switch is used to select the usage mode of the VTR/
RM multi-pin connector.
RM : This setting is used when connecting with the
camera control unit.
VTR : This setting is used when connecting and recording
using an external VCR
7
BACK Tally lamp
This lamp lights when the unit is in the recording mode. The
lamp flashes when the unit is shifting to the recording mode.
The lamp status and the lighting method can be selected in
No.082 BACK TALLY MODE of the VCR Setup menu.
See page 74, "BACK TALLY MODE"
The lamp blinks when the camera control unit is connected
and while CALL button 2 is held down. The lamp turns off
when the CALL button is released. The lamp flashes when
a call signal is received from a camera control unit operator.
For details on the tally lamp display when connecting the
camera remote control unit, See page 95.
u
y
t
e
r
w
DC IN
/BATT.
q