Configuring A Pxe Server - HP t820 Maintenance & Service Manual

Table C-6
Client ID
MASK
DHCP IP
2.
If you are running in a Microsoft RIS PXE environment press the
service boot as soon as the DHCP IP information appears on the screen.
If the unit does not boot to the network the server is not configured to PXE.
If you missed the F12 cue, the system will try to boot to the ATA flash that is not present. The
message on the screen will read: ERROR: Non-system disk or disk error. Replace and
press any key when ready.
Pressing any key will restart the boot cycle.

Configuring a PXE Server

NOTE:
All PXE software is supported by authorized service providers on a warranty or service
contract basis. Customers that call the HP Customer Service Center with PXE issues and questions
should be referred to their PXE provider for assistance.
Additionally, refer to the following:
– For Windows 2008 R2:
– For Windows 2012:
The services listed below must be running, and they may be running on different servers:
1.
Domain Name Service (DNS)
2.
Remote Installation Services (RIS)
NOTE: Active Directory DHCP is not required, but is recommended.
Diskless Unit Troubleshooting (continued)
Information from server
Information from server
Information from server
http://support.microsoft.com/kb/891275
http://technet.microsoft.com/en-us/library/cc766320(WS.10).aspx
If no Client ID information there is no network
connection. This may be caused by a bad cable, the
server is down, or a bad system board. Contact the Call
Center for service for the bad system board.
If no MASK information there is no network connection.
This may be caused by a bad cable, the server is down,
or a bad system board. Contact the Call Center for
service for the bad system board.
If no DHCP IP information there is no network
connection. This may be caused by a bad cable, the
server is down, or a bad system board. Contact the Call
Center for service for the bad system board.
F12 key to activate the network
Configuring a PXE Server
81