Table of Contents
Advertisement
If using a new heat sink, go to step 3.
1.
If reusing the existing heat sink, clean bottom of the heat sink and apply the thermal material
provided in the spares kit to the top of the processor.
2.
Position the heat sink atop the processor.
3.
If using a new heat sink, remove the protective covering from the bottom of the heat sink and
place it in position atop the processor.
4.
Secure the heat sink to the system board with the 4 captive screws.
CAUTION:
an X) to evenly seat the heat sink on the processor. This is especially important as the pins on the
socket are very fragile and any damage to them may require replacing the system board.
28
Chapter 4 Removal and replacement procedures
Heat sink retaining screws should be tightened in diagonally opposite pairs (as in
Advertisement
Table of Contents
Troubleshooting
