Drive cage (fiber NIC assembly holder)
Description
Drive cage
The drive cage sits behind the USB ports on the front of the chassis.
On this thin client, the drive cage does not support drives. The only component the drive cage houses is
the fiber NIC assembly.
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
Remove the two Torx screws that secure cage to the chassis (1), lift the tab (2) on the cage, slide
the cage toward the rear of the unit (3), and then pull the cage up and out of the chassis.
To install the drive cage, reverse the removal procedures.
34
Chapter 4 Removal and replacement procedures
(Preparation for disassembly on page
(Access panel on page
18).
Spare part number
732761-001
17).